El tema es, que tengo solo linux (slack 11, kernel 2.4.33.3 ) y los muchachos (ahora son muchachos, antes manga de hdp) no dan soporte para nada que no sea Microsoft (cosa que todos ya sabemos). eth0, levanta perfecto, y llego a la configuracion del Tainet CA61E, pero no logro realizar la conexion a arnet, para darme de alta.
Que cojones debo tocar?
Esto es la config del router
------
- Código: Seleccionar todo
WAN
IP Address Subnet Mask MAC Address
0.0.0.0 255.255.255.0 02:XX:41:XX:1B:XX
LAN
IP Address Subnet Mask MAC Address
10.0.0.2 255.0.0.0 00:D0:41:09:1B:17
WAN Configuration
System Wide Settings
Default Gateway VPI VCI Static Ip address Subnet Mask
0.0.0.0 0 33 0.0.0.0 255.255.255.0
ATM : UBR, Bandwith 0kbps
Encapsulation: PPPoE LLC
Bridge Disabled
Service Name ARNET
Username telecom@telecom /* Es de prueba, solo permite conexion a habilitacion.arnet.com.ar*/
Password nuevo
Disconnectd Timeout 0
Authentication PAP
Automatic Reconnect Yes
DHCP Client Enabled
Virtual Circuit 0
DNS 200.45.191.35 200.45.191.40 (los de arnet)
Route Table
Destination Netmask Gateway Interface
0.0.0.0 255.255.255.0 0.0.0.0 ss1
0.0.0.0 0.0.0.0 200.3.60.9 ppp1
10.0.0.0 255.0.0.0 10.0.0.2 br0
127.0.0.1 255.0.0.0 127.0.0.1 lo0
200.3.60.9 255.255.255.255 201.253.86.72 ppp1
Diagnostic Test
Checking LAN Connection
Testing Ethernet LAN connection : PASS HELP
Checking ADSL Connection
Testing ADSL Synchronization : PASS HELP
Checking Circuit 0 for Network Connection
Test ATM OAM Segment Loop Back : FAIL HELP
Test ATM OAM End-to-End Loop Back : FAIL HELP
Test Ethernet connect to ATM : PASS HELP
Test IP connect to Ethernet : FAIL HELP
Checking Circuit 1 for Network Connection
Test ATM OAM Segment Loop Back : FAIL HELP
Test ATM OAM End-to-End Loop Back : FAIL HELP
Test Ethernet connect to ATM : PASS HELP
Test IP connect to Ethernet : FAIL HELP
Checking Circuit 2 for Network Connection
Test ATM OAM Segment Loop Back : FAIL HELP
Test ATM OAM End-to-End Loop Back : FAIL HELP
Test Ethernet connect to ATM : PASS HELP
Test PPP Layer connection : FAIL HELP
Test IP connect to PPP : SKIPPED HELP
-----------
log del router, que me asigna una ip publica,
- Código: Seleccionar todo
1/1/1970 0:0:0> Ethernet Device 0 Detected
1/1/1970 0:0:0> ATM: Detected
1/1/1970 0:0:0> ATM: Setting up vcc0, VPI=0, VCI=33
1/1/1970 0:0:0> ATM: Setting up vcc1, VPI=8, VCI=35
1/1/1970 0:0:0> ATM: Setting up vcc2, VPI=8, VCI=65
1/1/1970 0:0:28> ATM Connected
1/1/1970 0:0:28> ATM layer is up, cell delineation achieved
1/1/1970 0:0:28> ADSL connected
1/1/1970 0:0:28> PPP2 PPPoA Connected
1/1/1970 0:0:31> PPP1 PPPoE Session is established.
1/1/1970 0:0:34> PPP PAP Authentication success
1/1/1970 0:0:34> PPP1: IP Protocol Up
1/1/1970 0:0:34> PPP1: PPP IP address is 190.30.204.202
1/1/1970 0:0:34> PPP1: PPP Gateway IP address is 200.3.60.9
1/1/1970 0:0:34> PPP1: DNS Primary IP address is 200.45.191.35
1/1/1970 0:0:34> PPP1: DNS Secondary IP address is 200.45.191.40
1/1/1970 0:0:34> PPP1 Session is up.
- Código: Seleccionar todo
root@darkstar:/home/usuario# ifconfig
eth0 Link encap:Ethernet HWaddr 00:13:8F:08:3D:D3
inet addr:10.0.0.13 Bcast:255.255.255.255 Mask:255.0.0.0
UP BROADCAST NOTRAILERS MULTICAST MTU:1500 Metric:1
RX packets:53509 errors:0 dropped:0 overruns:0 frame:0
TX packets:53823 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:3540959 (3.3 MiB) TX bytes:3088385 (2.9 MiB)
Interrupt:10 Base address:0xd400
mientras, sigo buscando por internet
edit: la ip de la lan es 10.0.0.0, porque asi viene en el router, y tenia ganas de tocarla, si estoy por dhcp, igual la voy a cambiar a 192, si logro hacer andar esto